|
|
signals
Nov 22, 2007 13:29:40 GMT -7
Post by tholme1 on Nov 22, 2007 13:29:40 GMT -7
Just wondering if the bike needs to be running in order for the signals to light up and function. I have had computer probs so now that I am up and running I will responde to some of my messages. tholme1
|
|
|
|
signals
Nov 24, 2007 18:14:32 GMT -7
Post by airdreams1 on Nov 24, 2007 18:14:32 GMT -7
they should work even with the bike off, the batery is good.
|
|
|
|
signals
Nov 25, 2007 18:08:48 GMT -7
Post by tholme1 on Nov 25, 2007 18:08:48 GMT -7
Air dreams do mean that the motor does not need to run in order for the signals to work?
I have purchased a set of emgo flush mount signals that were 12v, swapped the bulbs like t.c.r says ( they dont work } I have used a test light and have no power at my signal connectors front and rear?...... I have tailight neutral light low oil indicator light no hi/lo beam light no turn signal light obviously. I have replaced all bulbs in the speedo rear signals are stock. I was wondering if the way the stock signals are mounted that maybe they ground to the bike via the steel threaded tube and nutt that mounts them as well as the black signal wire ? send me an email with shipping address as I will send u that grab rail. thanx tholme1
|
|
